Hallicrafters S-16 SX-16 Alignment Manual (PDF)

The Hallicrafters manual for the Super Skyrider models S-16 and SX-16 provides detailed procedures for alignment, including intermediate frequency alignment and RF alignment, as well as instructions for setting up and operating the receiver. It also includes troubleshooting tips, such as checking tube bias and voltage, addressing audio squeals, and resolving issues with oscillation and noise.

  • Brand: Hallicrafters
  • Model: S-16
  • Type: manual
  • File size: 742.9 KB

Manual Overview

The Hallicrafters Super Skyrider models S-16 and SX-16 manual focuses on alignment procedures, troubleshooting, and calibration for optimal performance. For intermediate frequency alignment at 465 kHz, set controls to specific positions, remove the oscillator tube, and connect a signal generator to the 6L7 tube grid. Adjust trimmers T4, T3, T2, and T1 for maximum output. For crystal models, use an external oscillator. The RF alignment procedure requires specific condenser and resistor setups depending on the band, with adjustments for low and high frequency ends using padders and trimmers. Troubleshooting guidance includes checking the grid cap of the 6R7 tube for audio issues, verifying bias and voltage levels, and addressing high-pitch squeals by reversing audio transformer grid wires. For oscillation problems, inspect 6K7 tubes and replace a 300-ohm bias resistor with a 400-ohm one if necessary. The manual provides detailed voltage measurements and suggests using a 1000 ohms per volt meter for accuracy.

Quick Issues Covered

  • Diagnose power-up failures by checking RF tube bias and voltages.
  • Adjust IF trimmers for maximum output at 465 kHz.
  • Use schematics for circuit tracing and dead set troubleshooting.

Download PDF (742.9 KB)

Leave a Comment