The service manual for Hallicrafters models FM-46, 48, 52, and 54 provides detailed instructions on setup, operation, and troubleshooting, including alignment procedures for AM and FM, dial cord restringing, and chassis removal. It also includes technical specifications, component locations, and a service repair parts list to assist with maintenance and repairs.
Manual Overview
The service manual for Hallicrafters models FM-46, 48, 52, and 54 provides detailed guidance on troubleshooting, calibration, and adjustments for these radio receivers. The FM-46 and 52 models feature plastic cabinets, while the FM-48 and 54 have wood cabinets. The FM-52 and 54 include an electrical clock, differentiating them from the FM-46 and 48. The manual emphasizes the importance of proper alignment and calibration using RF and IF sweep generators, with specific steps outlined for AM and FM alignment. For AM alignment, adjustments involve tuning capacitors and coils to achieve maximum gain and symmetrical curves at specified frequencies. FM alignment requires similar procedures, focusing on achieving a centered “S” curve at 10.7 MHz. The manual also includes a schematic diagram and a service repair parts list, noting corrections for certain components. Technicians are advised to use non-metallic tools for adjustments and to handle the chassis carefully to avoid damaging connections. The manual provides guidance on dial cord restringing and specifies the removal process for the chassis.
Quick Issues Covered
- Diagnose power-up failures in models FM-46, 48, 52, and 54.
- Calibrate AM/FM alignment using specified signal generator settings.
- Trace circuits with detailed schematic diagrams for troubleshooting.
Overview
The document provides service data and technical specifications for Hallicrafters models FM-46, 48, 52, and 54. The FM-46 and 52 models have plastic cabinets, while the FM-48 and 54 models have wood cabinets. The FM-52 and 54 models include an electrical clock and additional circuitry. The manual covers selectivity, audio output, hum and noise levels, AFC hold range, speaker specifications, AGC figure of merit, tuning ranges, image rejection, and alignment procedures for both AM and FM. It also includes details on dial cord restringing, chassis removal, and service repair parts.
Specifications
- Selectivity
- LF. Bandwidth
- Audio Output
- Hum and Noise
- AFC Hold Range
- Speaker
- Transistors
- LF. Frequencies
- Sensitivity
- Tuning Ranges
- Image Rejection
- Antennas
- Power Source
- Dimensions (HWD)
Installation / Setup
The source does not provide specific information on installation or setup highlights such as wiring, clearances, calibration, or prerequisites.