Operator’s manual (December 2014) for the Teledyne LeCroy WaveJet Touch series of touch-screen digital oscilloscopes. It covers first-time setup, channel and trigger settings, timebase and memory options, zoom and replay, cursors and automatic measurements, math and FFT, pass/fail testing, saving data and remote control.
What this manual covers
- Safety precautions, operating environment, cooling and power
- Tour of the front panel, rear panel and touch-screen display
- Setup: placement, power, menu language, trace and grid intensity, date and time, probe phase correction
- Vertical settings: coupling, bandwidth limit and digital filters, probe ratio, invert, units, rescale, deskew, auto setup, default setup and XY display
- Triggering (setup, level, modes, stop/restart) and the timebase: acquisition modes, equivalent-time sampling, roll mode, memory length, half vs. full channel mode
- Zoom, waveform replay, cursors and automatic measurements, including pass/fail testing and measurement logging
- Math traces (add, subtract, multiply, integral, derivative, FFT) and reference waveform memories
- Display options, utilities (printing, calibration, status and firmware update, remote control, auxiliary output) and saving to internal or USB memory
- Maintenance, calibration and repair requests, storage and transport, and a troubleshooting guide
Key specifications
- 7.5-inch color VGA touch screen, 640 × 480 pixels
- The unit shown in the manual, a four-channel WaveJet Touch 354, is labeled 500 MHz, 2 GS/s
- Front (as pictured): four channel inputs, external trigger input, probe calibration terminal, USB port
- Rear: GPIB, USB device port (remote control or printer), Ethernet (LAN), auxiliary output (trigger or pass/fail), Kensington lock slot
About this document
- WaveJet Touch Oscilloscopes Operator’s Manual, December 2014, part number 924497 Rev A (Teledyne LeCroy)
- 90 pages, English
- Operator-level manual: no service procedures and no full specification table (Teledyne LeCroy publishes those separately)