The service manual for the Hammarlund HQ-110A/VHF and HQ-170A/VHF receivers provides detailed instructions on setting up, operating, and troubleshooting the equipment, including tuning amateur frequencies from 160 meters through 2 meters and improving sensitivity on the 6-meter band using a low noise pre-amplifier. It also includes a field alignment procedure, schematic diagrams, and parts lists to assist with maintenance and optimal performance of the receivers.
Manual Overview
The Hammarlund HQ-110A/VHF and HQ-170A/VHF service manual focuses on troubleshooting, diagnostics, and calibration for these receivers, which cover amateur frequencies from 160 meters to 2 meters. For troubleshooting, the manual emphasizes the importance of correct antenna connections and the use of separate antennas for 6 and 2-meter operations to prevent signal interference. It highlights the role of the 6CW4 pre-amplifier in enhancing sensitivity on the 6-meter band. The manual provides detailed alignment procedures, requiring a signal generator and alignment tools, and specifies adjustments for components like coils L205, L206, L207, and L208 to achieve peak performance. Calibration involves tuning the receiver and signal generator to specific frequencies, with careful adjustments to components like L209 to eliminate spurious responses. The manual also includes board-level guidance with schematic diagrams and parts lists to assist in component identification and replacement.
Quick Issues Covered
- Diagnose power-up failures with volume control knob position.
- Calibrate L205 and L206 for optimal 6-meter reception.
- Trace circuit issues using detailed schematic for HQ-110A/VHF.
Overview
The Hammarlund HQ-110A/VHF and HQ-170A/VHF are receivers designed to tune all amateur frequencies from 160 meters through 2 meters, providing reception for CW, AM, and SSB signals. The manual covers operation instructions, including the use of a bandswitch and volume control for receiving 6 meter and 2 meter signals, as well as recommendations for antenna connections. It also details the theory of operation, including the use of a low noise 6CW4 pre-amplifier stage and a converter circuit with 6CW4 Nuvistor tubes. The manual includes a field alignment procedure and emphasizes the importance of using a good antenna for VHF frequencies.
Specifications
- HQ-110A/VHF and HQ-170A/VHF Receivers
- – Tunes amateur frequencies from 160 meters through 2 meters
- – Reception of CW, AM, and SSB signals
- – 6CW4 pre-amplifier stage for improved sensitivity on 6 meter band
- – Uses 4 type 6CW4 Nuvistor tubes
- – Crystal controlled oscillator with 31.333 Mc crystal
- – Output frequency of 94 Mc
- – Broadband filter approximately 5 Mc wide
- – Tunable neutralizing coil L211
- – Series trap tuned to 188 Mc to prevent spurious response
Operation
To receive 6 meter signals (50 to 54 Mcs), place the bandswitch in the 50 to 54 Mc position and push in the volume control knob. Ensure a suitable antenna is connected to the appropriate terminal. For improved sensitivity on the 6 meter band, a low noise 6CW4 pre-amplifier stage is used. When the bandswitch is in the 50 to 54 Mc position and the volume control knob is pulled out, frequency converter stages activate to change 144 to 148 Mc signals to 50 to 54 Mc signals. It is recommended to push in the volume control knob when not receiving 2 meter signals to reduce power consumption. Separate antennas are recommended for 6 and 2 meter operation, and a switching unit should be used if a combination 6/2 meter antenna is desired. On 6 and 2 meters, the sideband switch is reversed due to the high frequency oscillator being used on the low side of the incoming signal.