The manual for the Hallicrafters Sky Buddy Model S-19 provides detailed instructions for the alignment procedure, including intermediate and radio frequency alignment, to ensure optimal performance of the receiver. It also outlines specific steps for setting up the signal generator and adjusting various components to achieve maximum signal output, as well as guidance on using an output meter for troubleshooting.
Manual Overview
The Hallicrafters Sky Buddy Model S-19 manual outlines procedures for intermediate frequency and radio frequency alignment. For intermediate frequency alignment, set the controls with A.V.C. and B.F.O. off, adjust the A.F. gain for maximum volume, and set the main dial to 1,800 KC. Connect a signal generator through a 2 µF condenser to the 6K8 mixer oscillator tube’s grid, grounding the generator to the chassis. Use a 455 KC signal and adjust condensers on T1 and T2 for maximum output. For radio frequency alignment, replace the condenser with a 400-ohm resistor, connect the generator to the A1 terminal, and perform pad and trimmer adjustments for different bands. Band 1 requires settings at 1,400 KC and 600 KC, Band 2 at 4 MC and 1.8 MC, and Band 3 at 14 MC and 7 MC. Adjustments should be made for maximum signal output, with the main condenser “rocked” across frequencies for precision.
Quick Issues Covered
- Intermediate frequency alignment at 455 kHz for Model S-19.
- Radio frequency alignment using signal generator for maximum signal.
- Schematic diagram aids in circuit tracing for troubleshooting.
Overview
The document provides an alignment procedure for the Sky Buddy Model S-19 radio by Hallicrafters Inc. It includes instructions for intermediate frequency alignment and radio frequency alignment, detailing specific settings and adjustments for optimal performance.
Specifications
Model S-I9
Operation
The manual provides detailed alignment procedures for the Sky Buddy Model S-19. It includes steps for intermediate frequency alignment and radio frequency alignment. For intermediate frequency alignment, the controls should be set with the A.V.C. and B.F.O. control off, the band switch on #1 band, and the main dial at 1,800 KC. A signal generator is connected to the grid of the 6K8 mixer oscillator tube, and adjustments are made for a 455 KC signal output. Condensers on T1 and T2 are adjusted for maximum signal output.
For radio frequency alignment, a 400-ohm resistor replaces the condenser in series with the generator lead. The generator is connected to the A1 terminal on the rear chassis, and adjustments are made for both low-frequency and high-frequency ends of the bands. Specific adjustments are detailed for Band No. 1, Band No. 2, and Band No. 3, involving setting the generator and receiver to specific frequencies and adjusting trimmers and pads for maximum signal output.