Hallicrafters S-16 Aligment Procedure Schematics Manual (PDF)

The Hallicrafters manual provides detailed instructions for the alignment procedure of the Super Skyrider models S-16 and SX-16, including specific settings for intermediate frequency alignment and RF alignment. It also offers troubleshooting tips for common issues such as high-pitch audio squeals, noisy coils, and low signal levels, suggesting component checks and replacements to resolve these problems.

  • Brand: Hallicrafters
  • Model: S-16
  • Type: manual
  • File size: 1.2 MB

Manual Overview

The Hallicrafters Super Skyrider Models S-16 and SX-16 manual provides detailed instructions for alignment, diagnostics, and troubleshooting. For alignment, the intermediate frequency (IF) is set at 465 kHz, with specific trimmers adjusted for maximum output. The RF alignment procedure involves using a signal generator and adjusting trimmers and padders for various frequency bands. Calibration requires careful adjustment of the tuning gang and checking for image frequencies, which should be slightly lower than the fundamental or harmonic signals. Troubleshooting guidance includes checking for loud hums to verify the audio section, inspecting bias and voltage levels on RF tubes, and addressing issues like high-pitch squeals or noisy components by adjusting or replacing parts. If the receiver develops low signal and high noise levels, replacing the 6L7 tube is recommended. For violent oscillations, checking and possibly replacing the 6K7 tubes and adjusting the bias resistor are suggested. The manual emphasizes using a rectifier-type meter for output indication and provides board-level guidance for component adjustments.

Quick Issues Covered

  • Diagnose dead beat oscillator with 6J7 tube checks.
  • Adjust trimmers for maximum output during IF alignment.
  • Use schematics for circuit tracing and voltage checks.

Download PDF (1.2 MB)

Leave a Comment