The service manual for the Hallicrafters Model CRX-101 provides detailed instructions on restringing the dial cord, including removing the receiver from the cabinet and securing the tuning capacitor pulley. It also includes alignment procedures and a repair parts list for troubleshooting and maintaining the receiver.
Manual Overview
The Hallicrafters CRX-101 service manual provides detailed procedures for dial cord restringing, receiver alignment, and component specifications. For dial cord restringing, the manual instructs technicians to remove the receiver from its cabinet, unmesh the tuning capacitor plates, and follow a specific sequence to string the dial cord, ensuring proper tension and alignment. Receiver alignment requires specific test equipment, including an audio power meter and RF signal generator. The alignment process involves connecting the signal generator to various points on the receiver and adjusting components such as IF transformers and oscillator trimmers for maximum audio output. The manual includes an alignment chart detailing the necessary connections and adjustments. Additionally, the service manual provides a comprehensive parts list, including capacitors, resistors, coils, transformers, transistors, and diodes, with corresponding part numbers for easy identification and replacement. This information is crucial for technicians performing repairs and maintenance on the CRX-101 model.
Quick Issues Covered
- Diagnose power-up failures with battery and tuning capacitor checks.
- Calibrate receiver using RF signal generator and alignment chart.
- Use schematics for circuit tracing and component identification.
Specifications
- Circuit: Single band superheterodyne with untuned RF stage, Circuit contains 9 transistors and 3 diodes
- Tuning Range: 108-135 MHz
- Input Impedance (external antenna): 50 ohms
- Sensitivity: .12uV for 12db 8/N
- Selectivity (IF): 120KHz at 6db
- IF Rejection: 40db min
- AGC Figure of Merit: 40db min
- IF Frequency: 10.7 MHz
- Audio Output: 150 milliwatts
- Audio Distortion: 7% max, at 50 milliwatts
- Power Source: 9VDC (one Burgess 2U6 or equivalent)
- Battery Drain: 15 MA (without input signal)