The manual for the Wavetek Model 141 Voltage-Controlled Generator provides detailed instructions on setting up, operating, and troubleshooting the device, including information on its function as a frequency modulated generator and its output amplitude calibration. It also includes sections on circuit descriptions, maintenance procedures, and a parts list to assist with repairs and replacements.
Overview
Refer to the PDF for details.
Specifications
- VERSATILITY
- Waveforms: Sine, square, triangle, and sync output.
- Dynamic Frequency: 0.5 Hz to 5 MHz.
- Dial calibrated from 0.5 to 5 on the frequency dial.
- Ranges Dial: X10 0.5 Hz to 50 Hz, X100 5 Hz to 500 Hz, X1K 50 Hz to 5 kHz, X10K 500 Hz to 50 kHz, X100K 5 kHz to 500 kHz, X1M 500 kHz to 5 MHz.
- Outputs: Main output selectable. Maximum amplitude approximately 20 V p-p into an open circuit with calibrated 10 V p-p into a 50-ohm load.
- Precision output attenuator in 10-db steps and 10-db vernier giving overall attenuator capability of greater than 50 db.
- Output impedance is 50 ohms. Short circuit output current +100 mA.
- Sync Output: Positive and negative pulses coincident with the positive and negative transitions of the square wave.
- VCG—Voltage Controlled Generator: Up to 1000:1 frequency change with external voltage input.
Controls & Indicators
Refer to the PDF for details.
Installation / Setup
Refer to the PDF for details.
Operation
Refer to the PDF for details.
Troubleshooting & Error Codes
Refer to the PDF for details.
Safety & Warnings
Refer to the PDF for details.
Download 141 Manual (PDF – 1.6 MB)
Wavetek 141 Manual PDF (1.6 MB): Guides technicians in troubleshooting and calibrating the Wavetek 141 model efficiently.
- Brand: Wavetek-model
- Model: 141
- Type: Manual
- File size: 1.6 MB