Components

SAMSUNG SKK8MC Multi-Control Kit Ins 1

CAUTION
Proceed to STEP 4 of the ‘Stacking Kit Installation Instructions’ provided with the SKK-8K stacking kit. Then, on the back of the washer, assemble the provided ASSY BRACKET STACKING on the right side, and assemble the REAR BRACKET (provided with the SKK-8K stacking kit) on the left side. Use the screws provided with the SKK-8K stacking kit to fasten both brackets.

STEP 1. DO NOT TIGHTEN SCREWS COMPLETELY.
LOOSELY fasten two REAR BRACKETS at the back of the washer using the two SCREWS-HEX HEAD (6002-001431) and WASHERS (DC60-00044A). SCREWS-HEX HEAD and WASHERS are included in the SKK-8K stacking kit.

SAMSUNG SKK8MC Multi-Control Kit Ins 2
  1. Fasten the ASSY BRACKET STACKING on the right-side.
  2. Fasten the other REAR BRACKET on the left-side.

In case you already have a dryer stacked to a washer, and you are replacing the dryer with the new one, remove the old REAR BRACKET on the right side and replace with the provided ASSY BRACKET STACKING.

STEP 2.

SAMSUNG SKK8MC Multi-Control Kit Ins 3

Put the dryer on the washer, as shown in the figure. Leave a little space between the dryer and the bracket.

CAUTION

  • To prevent noise, make sure the washer is level, and the dryer’s leveling legs are tightened up. (Stacking Kit: SKK-8K, for 27” models)
  • For detailed instructions on stacking, see the “Stacking Kit Installation Instructions”.
  • Make sure to keep the wire (of the ASSY BRACKET STACKING) away from the top of the washer before stacking the dryer.

STEP 3.
Follow the STEP 7 ~ STEP 10 of the ‘Stacking Kit Installation Instructions’ provided with the SKK-8K to assemble the bracket on the rear side of the washer. Assemble the provided ASSY BRACKET STACKING on the right side and assemble the REAR BRACKET (provided with the SKK-8K stacking kit) on the left side. All the necessary parts are included in the stacking kit.

SAMSUNG SKK8MC Multi-Control Kit Ins 4

STEP 4.
Open the connector port cover on the dryer and the washer, connect the wire on both ports, and then close the cover.

SAMSUNG SKK8MC Multi-Control Kit Ins 5
  • Be careful not to damage the wire by the connector port cover.
  • Do not pull the wire too hard to remove the connector from the port.

STEP 5.

SAMSUNG SKK8MC Multi-Control Kit Ins 6

There are two HOLDER WIRE pre-assembled to the wire. Attach each HOLDER WIRE to the dryer and the washer. Check and make sure the washer and the dryer are connected.

Documents / Resources

SAMSUNG SKK8MC Multi-Control Kit [pdf] Instruction Manual
SKK8MC Multi-Control Kit, SKK8MC, Multi-Control Kit

Leave a comment

Your email address will not be published. Required fields are marked *