Bicycle Mount

1 Install the included mounting bracket onto bicycle handlebars.

JBL WIND3S Portable Speakers A2
2 Dock/undock the speaker into the mounting bracket effortlessly

JBL WIND3S Portable Speakers A3
JBL WIND3S Portable Speakers A11WHAT’S IN THE BOX
JBL WIND3S Portable Speakers A4

 WIND3S

JBL WIND3S Portable Speakers A5               JBL WIND3S Portable Speakers A6
X1 bracket                 X1 non-slip pads(big)

JBL WIND3S Portable Speakers A7                                        JBL WIND3S Portable Speakers A8
X1 non-slip pads(small)         X1 plastic screw

JBL WIND3S Portable Speakers A9                                     JBL WIND3S Portable Speakers A10
X1 USB cable                  X1 QSG

JBL WIND3S Portable Speakers A12BUTTONS
JBL WIND3S Portable Speakers A13
  1. Volume Up
  2. Play/Pause*
  3. Volume Down
  4. Previous Track
  5. Power On / Off
  6. Bluetooth
  7. Next Track

*long press to switch EQ between ‘Sport’ and ‘Bass’ mode

JBL WIND3S Portable Speakers A14Bluetooth pairing
JBL WIND3S Portable Speakers B1
JBL WIND3S Portable Speakers B2
JBL WIND3S Portable Speakers B3CHARGING
JBL WIND3S Portable Speakers BA5
JBL WIND3S Portable Speakers B6WATERPROOF DUSTPROOF IP67
JBL WIND3S Portable Speakers B7
TECH SPEC
Transducer:43 x 47 mm / 1.5″
Output power:5 W RMS
Frequency response:110 Hz – 20 kHz
Signal-to-noise ratio:> 85 dB
Battery capacity:1050 mAh
Battery charge time:2.5 hours (5 V DC Voltage A 1 A)
Music play time:up to 5 hours (dependent on volume level and audio content)
Bluetooth® version:5.0
Bluetooth® profile:A2DP 1.3, AVRCP 1.6
Bluetooth® transmitter frequency range:2400 MHz – 2483.5 MHz
Bluetooth® transmitter power:<6 dBm (EIRP)
Bluetooth® transmitter modulation:GFSK, π/4 QPSK, 8DPSK
Dimensions (W x H x D):90 mm x 73.2 mm x 35.8 mm
Weight:0.230 kg
Maximum operation temperature:45 °C
SENCO F-35XP - DANGER

To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL Wind 3S to liquids without removing cable connection. Do not expose JBL Wind 3S to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker.
When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.

JBL WIND3S Portable Speakers B8

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

EAC

CA_JBL_WIND3S_QSG_Global_SOP_V12

Documents / Resources

JBL WIND3S Portable Speakers [pdf] User Guide
WIND3S Portable Speakers, WIND3S, Portable Speakers

Leave a comment

Your email address will not be published. Required fields are marked *