Overview
Refer to the PDF for details.
Specifications
Refer to the PDF for details.
Controls & Indicators
Refer to the PDF for details.
Installation / Setup
Refer to the PDF for details.
Operation
Refer to the PDF for details.
Troubleshooting & Error Codes
Refer to the PDF for details.
Safety & Warnings
Refer to the PDF for details.
Download PROGRAMMING Manual (PDF – 1.2 MB)
HP-83711A/B Programming Manual PDF (1.2 MB) guides technicians in programming and configuring HP-83711A/B signal generators.
- Brand: Hp-83711a-b-12a-83711b-12b
- Model: PROGRAMMING
- Type: Manual
- File size: 1.2 MB
Overview
Brief overview of the product.
Specifications
- Key spec 1
- Key spec 2
Controls & Indicators
Control panel/button layout.
Installation / Setup
- Step 1…
- Step 2…
Operation
Basic usage, modes, cycles.
Troubleshooting & Error Codes
| Issue / Code | Fix |
|---|---|
| Example | How to fix… |
Safety & Warnings
- Important warning…
Downloads
Download PROGRAMMING manual (PDF)
HP 83711A/B-12A/12B Programming Manual Overview
The HP 83711A and 83711B series are precision microwave signal generators designed for advanced testing and measurement applications. These devices provide stable, low-phase-noise continuous wave (CW) signals over a wide frequency range, making them ideal for use in communications, radar, and electronic warfare system development. The programming manual offers detailed instructions on controlling the signal generators via remote interfaces, enabling automated test setups and enhanced measurement accuracy.
Main Features and Specifications
- Frequency range: 2 GHz to 20 GHz (model-dependent)
- Output power: Typically up to +13 dBm with fine adjustment capability
- Low phase noise and high spectral purity for precise signal generation
- Remote programmability via GPIB/IEEE-488 interface
- Internal frequency modulation and pulse modulation options
- Compact and rugged design suitable for laboratory and field use
Basic Usage and Operation Tips
Before operating the HP 83711A/B signal generator, ensure it is properly connected to a calibrated power source and the output is terminated or connected to the measurement device. Use the front panel or remote programming commands to select the desired frequency and output power level. For automated testing, utilize the GPIB interface commands as described in the manual to configure frequency sweeps, modulation settings, and output control. Always allow the device to warm up for at least 20 minutes to achieve optimal frequency stability.
Troubleshooting and Maintenance Notes
If the output signal is unstable or absent, verify all cable connections and check for any error messages displayed on the unit. Regularly inspect the connectors and clean them to prevent signal degradation. Periodic calibration by an authorized service center is recommended to maintain measurement accuracy. Avoid exposing the device to excessive heat or moisture, and power cycle the unit if it becomes unresponsive.
Safety Reminder
Always follow standard electrical safety practices when operating the HP 83711A/B signal generator. Avoid direct exposure to microwave output signals to prevent potential health hazards. Disconnect the device from power before performing any maintenance or cleaning. Refer to the manual for detailed safety instructions and warnings to ensure safe and reliable operation.