The manual provides detailed instructions for installing the internal DMM assembly in the Agilent 34970A, including steps for disconnecting the power, removing the outer cover, connecting cables, and enabling the DMM for operation. It also includes guidance on modifying rear panel labeling and performing a zero adjustment procedure to ensure calibration accuracy.
Manual Overview
The HP-34970A Option 001 DMM installation manual provides detailed instructions for installing the internal DMM assembly using the 34970-80010 retrofit kit. Begin by disconnecting the power cord and removing the outer cover, following the procedures in chapter 6 of the 34970A Service Guide. Connect the internal DMM ribbon cable to the main circuit board at connector J202, ensuring the locking clips secure the cable. Install the internal DMM circuit board into the chassis, positioning it over the tabs and locking it in place with an audible click. Twist the DMM input cable (P101) once before connecting it to the backplane to maintain specifications. Enable the DMM via the front-panel Utility menu or the remote interface using the INST:DMM command. Modify the rear panel labeling by marking an “X” through the black circle if the DMM was not originally installed. Replace the outer cover as per the service guide. The internal DMM is pre-calibrated, but perform the Zero Adjustment procedure from chapter 4 of the service guide to ensure accuracy.
Overview
Agilent 34970A/Option 001 is a product that involves the installation of an internal DMM assembly using the 34970-80010 Retrofit Kit. The manual provides step-by-step instructions on how to install the internal DMM assembly into the Agilent 34970A, including disconnecting the power cord, removing the outer cover, connecting cables, installing and locking the circuit board, and enabling the internal DMM. It also includes instructions for modifying the rear panel labeling and replacing the outer cover. Calibration information is provided, indicating the internal DMM was pre-calibrated at the factory, and a Zero Adjustment procedure is recommended post-installation.
Specifications
Refer to the PDF for details.
Controls & Indicators
Refer to the PDF for details.
Installation / Setup
To install the Agilent 34970A/Option 001 internal DMM assembly, first disconnect the power cord and remove the outer cover following the procedures in chapter 6 of the 34970A Service Guide. Connect the internal DMM ribbon cable to connector J202 on the main circuit board and secure it with locking clips. Install the internal DMM circuit board into the chassis by positioning it over the tabs and locking it in place. Twist the internal DMM input cable at least one full turn before connecting it to the backplane connector to avoid compromising specifications. Enable the internal DMM from the front-panel or remote interface. Modify the rear panel labeling if necessary, and replace the outer cover. The internal DMM is pre-calibrated, but a Zero Adjustment procedure should be performed as per chapter 4 of the Service Guide.
Operation
Refer to the PDF for details.
Troubleshooting & Error Codes
Refer to the PDF for details.
Safety & Warnings
Refer to the PDF for details.
Download OPT.-001-DMM-INSTALLATION Manual (PDF – 72.3 KB)
HP-34970A OPT.-001-DMM-INSTALLATION manual guides technicians through the installation process of the DMM option.
- Brand: Hp-34970a
- Model: OPT.-001-DMM-INSTALLATION
- Type: Manual
- File size: 72.3 KB
Overview
Brief overview of the product.
Specifications
- Key spec 1
- Key spec 2
Controls & Indicators
Control panel/button layout.
Installation / Setup
- Step 1…
- Step 2…
Operation
Basic usage, modes, cycles.
Troubleshooting & Error Codes
| Issue / Code | Fix |
|---|---|
| Example | How to fix… |
Safety & Warnings
- Important warning…
Downloads
Download OPT.-001-DMM-INSTALLATION manual (PDF)