The operation manual for the HP-11042A covers the setup and operation of the probe coaxial "T" connector, which is used with the Model 410B/C Voltmeter to measure voltages in a 50-ohm transmission line. It provides instructions on connecting the probe to the transmission line and voltmeter, ensuring proper signal observation without damaging the capacitor, and includes troubleshooting tips for correct operation.
Overview
The Model 11042A Probe Coaxial “T” Connector is an accessory designed for use with the Model 410B/C Voltmeter. It is used to measure voltages between the center conductor and sheath of a 50-ohm transmission line. The connector features a frequency range of 100 Hz to 1000 MHz and is equipped with type N male and female line connectors. The manual provides instructions for connecting the Model 11042A to the transmission line and voltmeter, emphasizing careful insertion to avoid damage.
Specifications
- FREQUENCY RANGE: 100 Hz to 1000 MHz
- STANDING-WAVE RATIO: Maximum at 500 MHz: 1.1
- Maximum at 1000 MHz: 1.2
- LINE CONNECTORS: Type N male
- Type N female
Controls & Indicators
Refer to the PDF for details.
Installation / Setup
The installation/setup highlights for the Model 11042A Probe Coaxial “T” Connector include the following steps: Remove the tip from the Model 410B/C AC Probe and insert the diode probe into the large socket of the 11042A “T” connector. Turn the probe into the “T” connector only until a signal is observed on the 410B/C. Turning the probe all the way to the stops can damage the Model 11042A capacitor. The voltage at the point where the Model 11042A is inserted in the line can be read directly on the Model 410B/C AC scale. The Model 11042A has three connectors: two type N connectors for line connections and a large socket for the Model 410B/C AC Probe. Insert the Model 11042A in the line at the type N connectors and apply a signal to the transmission line.
Operation
The Model 11042A Probe Coaxial “T” Connector is used as an accessory for the Model 410B/C Voltmeter to measure voltages between the center conductor and sheath of a 50-ohm transmission line. The procedure for connecting it involves inserting the Model 11042A into the line using its type N connectors, applying a signal to the transmission line, removing the tip from the Model 410B/C AC Probe, and inserting the diode probe into the large socket of the 11042A “T” connector. The probe should be turned into the “T” connector only until a signal is observed on the 410B/C to avoid damaging the capacitor in the 11042A. The voltage at the point where the Model 11042A is inserted can be read directly on the Model 410B/C AC scale.
Troubleshooting & Error Codes
Refer to the PDF for details.
Safety & Warnings
TURN THE PROBE INTO THE “T” CONNECTOR ONLY UNTIL A SIGNAL IS OBSERVED ON THE 410B/C. TURNING THE PROBE ALL THE WAY TO THE STOPS CAN DAMAGE THE MODEL NO42A CAPACITOR IN THE 11042A.
Download NOTE Operation manual (PDF – 69.7 KB)
HP-11042A Operating Manual PDF: Guide for technicians to troubleshoot and operate the NOTE model efficiently. File size: 69.7 KB.
- Brand: Hp-11042a-operating
- Model: NOTE
- Type: Operation manual
- File size: 69.7 KB
Overview
Brief overview of the product.
Specifications
- Key spec 1
- Key spec 2
Controls & Indicators
Control panel/button layout.
Installation / Setup
- Step 1…
- Step 2…
Operation
Basic usage, modes, cycles.
Troubleshooting & Error Codes
| Issue / Code | Fix |
|---|---|
| Example | How to fix… |
Safety & Warnings
- Important warning…
Downloads
Download NOTE operation manual (PDF)