Overview

Honeywell Portable Single Gas - Reference Overview
Honeywell Portable Single Gas - Reference Overview-

Contact Us

Europe, Middle East, Africa
Life Safety Distribution GmbH
Toll-Free 00800 333 222 44
Middle East +971 4 450 5800
Middle East +971 4 450 5852
(Portable Gas Detection)
gasdetection@honeywell.com

Americas
Honeywell Analytics
Distribution Inc.
Tel: +1 847 955 8200
Toll free: +1 800 538 0363
detectgas@honeywell.com

Asia Pacific
Honeywell Analytics Asia Pacific
Tel: +82 (0) 2 6909 0300
India Tel: +91 124 4752700
analytics.ap@honeywell.com

Honeywell Portable Single Gas - QR

Technical Services
EMEA: HAexpert@honeywell.com
US: ha.us.service@honeywell.com
AP: ha.ap.service@honeywell.com
www.honeywellanalytics.com

https://www.honeywellanalytics.com/en/products/BW-Solo

Safety Certifications

Wireless Approvals
FCC ID: SU3BWS1
IC: 20969-BWS1
RED: RE-D Directive 2014/53/EU

IP Rating
IP66; IP68 1.2 meters for 45 minutes

Honeywell BW Solo is designed to operate via Bluetooth Low Energy to send data to a smartphone running Safety Communicator. The data can then be sent to computers running ProRAE Guardian monitoring software.

Honeywell Portable Single Gas - WARNINGS WARNINGS
– For safety reasons, this equipment must be operated and serviced by qualified personnel only.
– Read and understand the instruction manual completely before operating or servicing.
– Substitution of components may impact safety.
– Lithium battery: Only use approved battery: 2/3AA 3.6V 1.65Ah Lithium battery (P/N: 500-0160-000).
Honeywell Portable Single Gas - CautionCAUTION
– To reduce the risk of electric shock, turn the power off before opening this instrument or performing service.
– Never operate the instrument when the instrument is open.
– Service this product only in an area known to be non-hazardous.
– Recycling: this instrument contains a lithium battery. Do not mix with the solid waste stream. Spent batteries should be disposed of by a qualified recycler or hazardous
materials handler.
– This device complies with Part 15 of the FCC Rules / Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Common device’s operations

Honeywell Portable Single Gas - Common device
Power On5-second hold
Power Off5-second hold
Enter MenusDouble-click
Select NextSingle-click
Initiate SelectedLong Hold

IMPORTANT: Read the User Guide for complete information on the BW Solo operation.

Bump Test/Configuration

Honeywell Portable Single Gas - Press twice repeteadily
  1. Press twice repeteadily.
  2. Select Bump Test or Configuration, and then follow On-screen instructions until ‘‘Apply Gas?” is displayed.
  3. Place the calibration cap over the Honeywell BW Solo, and then hook the cap’s left clip to the corresponding groove of the detector.
    Honeywell Portable Single Gas -Place the calibration
  4. Press down on the tab to snap the right clip into place.
  5. Attach hose and open the cylinder valve by turning the pressure regulator knob counterclockwise.
    Honeywell Portable Single Gas - Remove the calibration cap
  6. Remove the calibration cap by pulling on the tab.

Leave a comment

Your email address will not be published.