tubefemdom.net

Honeywell RPWL300A Decor Wireless Push-Surface Mount Instruction Manual

RPWL300A

What is included

  • Bell push button
  • CR2032 battery
  • Mounting hardware
  • Adhesive pad

Safety

Always follow the manufacturer ’ s advice when using power tools and wear suitable protective equipment (e.g. safety goggles) when drilling holes etc. Before drilling holes in walls, check for hidden electricity cables and water pipes, the use of a cable/pipe locator may be advisable if in doubt.

Open the bell push

Insert a flat bladed screwdriver into slot A at the base of the push. Carefully lever the cover and base apart (Fig. 1).

Fig. 1

To install the push battery

Insert the CR2032 coin cell. Ensure the face marked ‘+ ’ is uppermost (Fig. 2).

Fig. 2

Mounting the bell push

Mount using either the double- sided adhesive pad or the screws provided (see Fig 3). Test your push before mounting. Avoid mounting on metal structures.

Fig. 3
Specification and Troubleshooting

Guarantee

Honeywell guarantees this product for 1 year from the date of purchase. Proof of purchase is required; this does not affect your statutory rights. If you require further information about your product, call the Honeywell help ­ line at 1-800-468-1502.

Disposal & Recycling

Batteries and waste electrical products should not be disposed of with house ­ hold waste. Please recycle where these facilities exist. Check with your local authority or retailer for recycling advice.

Declaration

Honeywell hereby declares that this product complies with Part 15 of the FCC rules and Industrial Canada standards. This device operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the users authority to operate the equipment.

Honeywell Logo

Decor Wireless Surface Mount Bell Push

  • Self-learning push simplifies programming.
  • Individually coded to avoid interference with other users.
  • Range dependent on door chime.
FCC Logo

Federal
Communications
Commission

Operating frequency: 916.8 MHz

Design reg. EU 3022897;
China ZL200630009379.9

Barcode

Proof of Purchase
Model RPWL300A1007
69-2131EFS-02

©2008 Honeywell International Inc.
All Rights Reserved.
Golden Valley, MN 55422 U.S.A.
Engineered by Honeywell
Made in China

http://yourhome.honeywell.com
1-800-468-1502

1-Year Limited Warranty

Documents / Resources

Honeywell Decor Wireless Push-Surface Mount PWL300A [pdf] Instruction Manual
Honeywell, Decor, Wireless Push-Surface Mount, PWL300A

Leave a comment

Your email address will not be published.