My Powergroom®/PowerSwift™ Pet Compact Upright Vacuum has no power | Support

Unplug vacuum Run hand along entire length of power cord, it should be smooth Check plug for damage If either the cord (not smooth or exposed wires) or plug (prongs) are damaged, visit a BISSELL Authorized Service Center or Contact Us Check to see if outlet is working: Test this by plugging in a cell phone charger …

My PowerForce®/Easy Vac® Lightweight Upright Vacuum is loud | Support

Unplug machine Slide dirt cup release lever to the right to remove dirt cup and empty Remove filter cup under dirt cup by pulling up Grasp circular filters, twist counterclockwise to unlock, and pull straight up to remove Separate black foam filter from inner pleated filter Black foam filter can be washed in warm water …

My SmartClean Canister Vacuum has no/low suction | Support

Remove the dirt cup by pushing the latch on the back of the top of the tank Empty the dirt cup Disconnect separator to remove debris/clean Separator can be rinsed in warm water with mild dish soap Allow to completely air dry before reinstalling (24 – 48 hours) Clean the filters Disconnect the tank lid Remove …

My ICONpet™ EDGE Cordless Vacuum has an Unusual Smell/Bad Odor | Support

What type of smell? Damp or musty? A damp or musty smell is likely caused by the following: Filters may have been reinstalled before they were completely dry Slightly moist debris, such as pet hair or food was vacuumed For steps on how to resolve this > Go to Cleaning Filters   Hot plastic? A unusual plastic smell is likely caused by …

My FeatherWeight/ReadyClean Cordless Vacuum is Blowing/Scattering Debris | Support

If your vacuum is blowing/scattering debris it is likely due to a clog or blockage: If the issue is due to a clog or blockage > Go to No Suction Read more: https://manuals.plus/bissell/my-featherweight-readyclean-cordless-vacuum-is-blowing-scattering-debris-support#ixzz7g1iMxCsV

My FeatherWeight™/Magic Vac Lightweight Stick Vacuum has no power | Support

Unplug vacuum Run hand along entire length of power cord, it should be smooth Check plug for damage If either the cord (not smooth or exposed wires) or plug (prongs) are damaged, visit a BISSELL Authorized Service Center or Contact Us Check to see if outlet is working: Test this by plugging in a cell phone charger …

My PowerClean®/PowerGroom®/PowerGlide® brush is not turning | Support

Document Unplug machine and turn machine over so bottom is facing up Remove access plate by lifting tab 1 near rear wheel and release latches 2-4 in front Remove brush and check the brush and belt for damage If brush will not turn by hand or belt is broken, replace the damaged part Clean off …

My PowerClean®/Healthy Home Upright Vacuum® has no power | Support

Unplug vacuum Run hand along entire length of power cord, it should be smooth Check plug for damage If either the cord (not smooth or exposed wires) or plug (prongs) are damaged, visit a BISSELL Authorized Service Center or Contact Us Check to see if outlet is working: Test this by plugging in a cell phone charger …