The Tektronix 475 service manual provides detailed instructions for setting up, operating, and troubleshooting the oscilloscope, including preliminary control settings and calibration procedures. It also includes diagrams of circuit boards and lists specific part numbers for components used in frequency response adjustments and signal interconnections.
Overview
Refer to the PDF for details.
Specifications
- Attenuator (two required): Attenuation ratio, X10; connectors, GR; impedance, 50 ohms.
- Attenuator: Attenuation ratio, X5; connectors, GR; impedance, 50 ohms.
- Termination (two required): Impedance, 50 ohms; accuracy, within 3%; connectors, BNC.
- T-Connector: Connectors, BNC.
- Input Normalizer: RC time constant, 20 picofarads times 1 megohm.
- Dual-Input Coupler (two required): Connectors, BNC; matched signal transfer to each input.
- Screwdriver: Three-inch shaft; 3/32-inch bit.
- Low-Capacitance Screwdriver: 1 1/2-inch shaft.
Controls & Indicators
Refer to the PDF for details.
Installation / Setup
Refer to the PDF for details.
Operation
Refer to the PDF for details.
Troubleshooting & Error Codes
Refer to the PDF for details.
Safety & Warnings
Refer to the PDF for details.
Download 2 Service manual (PDF – 63.8 MB)
Tektronix 475 Service Manual PDF: 63.8 MB. Provides technicians with procedures for troubleshooting and calibrating the Tektronix 475 Model 2.
- Brand: Tektronix-475-service-manual
- Model: 2
- Type: Service manual
- File size: 63.8 MB
Overview
Brief overview of the product.
Specifications
- Key spec 1
- Key spec 2
Controls & Indicators
Control panel/button layout.
Installation / Setup
- Step 1…
- Step 2…
Operation
Basic usage, modes, cycles.
Troubleshooting & Error Codes
| Issue / Code | Fix |
|---|---|
| Example | How to fix… |
Safety & Warnings
- Important warning…
Downloads
Download 2 service manual (PDF)