Heathkit EUW-15 HV DC Power Supply Schematics (PDF)

The Heathkit manual for the EUW-15 Power Supply provides detailed instructions for setup, operation, and troubleshooting, including specifications for voltage outputs, regulation, and controls such as the divider-regulator switch and voltage adjustment. It also includes information on the internal components like the tube complement and the schematic for proper wiring and voltage measurement.

  • Brand: Heathkit
  • Model: EUW-15
  • Type: manual
  • File size: 122.4 KB

Manual Overview

The Heathkit SCHEMATICS manual provides detailed guidance on troubleshooting, diagnostics, and adjustments for the EUW-15 Power Supply. For troubleshooting, the manual emphasizes checking the power supply’s output voltages and ensuring they fall within specified ranges: 200 to 350 volts DC for B+ and 6.3 volts AC for filament voltage. Error codes are not explicitly detailed, but diagnostics involve measuring voltage variations and ensuring they remain within 1% from no load to full load at 300 volts. Calibration involves setting the regulator for a 300 V output with no load and using an 11 megohm input VTVM for accurate voltage readings. Board-level guidance includes confirming resistor and capacitor values, with all resistors being 1/2 watt unless specified otherwise. The manual also highlights the importance of using the correct fuses and ensuring proper connections, especially when using the voltage divider as a variable load. Adjustments are made using the REGULATOR VOLTAGE control and various switches, such as the DIVIDER-REGULATOR and PRIMARY VOLTAGE switches.

Quick Issues Covered

  • Diagnose power-up failures with voltage-doubler operation checks.
  • Calibrate B+ voltage output for less than 1% variation.
  • Trace circuit issues using detailed schematic diagrams.

Specifications

  • B+ Voltage Output: 200 to 350 volts DC regulated, at 0 to 100 milliamperes continuous
  • Filament Voltage Output: 6.3 volts AC at 3 amperes
  • B+ Regulation: Output variation less than 1% from no load to full load at 300 volts, Output variation less than +1 volt for a +10 volt variation in the AC line input, Less than 10 millivolts rms ripple, jitter, and noise
  • B+ Output Impedance: Less than 10 ohms from 5-100,000 cps
  • Divider Voltages (Unregulated): Approximately 500, 400, 300, 200, and 100 volts
  • Voltage Divider: Internal, using five 1500 ohm 10 watt resistors; also can be used as a variable internal load
  • Variable Load: Voltage divider can be connected as a variable load, but current must not exceed 80 milliamperes
  • Tube Complement: 1 – 6L6GC, series regulator, 1 – 6BH6, control amplifier, 1 – OB2, voltage regulator
  • Controls And Switches: DIVIDER VOLTAGE (or variable load switch), DIVIDER-REGULATOR switch, REGULATOR VOLTAGE (MIN-MAX) control, POWER (ON-OFF) switch, HIGH VOLTAGE (ON-OFF) switch, PRIMARY VOLTAGE SWITCH (on the chassis)
  • Output Terminals: DC+ and DC-, FILament (6.3 VAC), Meter, Chassis ground

Controls & Indicators

The front-panel controls/indicators present are:

– DIVIDER VOLTAGE (or variable load switch)
– DIVIDER-REGULATOR switch
– REGULATOR VOLTAGE (MIN-MAX) control
– POWER (ON-OFF) switch
– HIGH VOLTAGE (ON-OFF) switch
– PRIMARY VOLTAGE SWITCH (on the chassis)

Download PDF (122.4 KB)

Leave a Comment