The Heathkit Bar Generator Model BG-1 manual provides detailed instructions for setting up the device, operating it to generate specific frequencies, and troubleshooting common issues. It includes specifications such as carrier frequency, modulating frequencies, output voltage, and power requirements, along with guidance on the use of components like the VHF oscillator coil and power transformer.
Manual Overview
The Heathkit Bar Generator Model BG-1 manual provides detailed guidance for technicians on troubleshooting, diagnostics, calibration, and board-level adjustments. The troubleshooting flow involves verifying power supply connections and ensuring the transformer-operated half-wave selenium rectifier is functioning correctly. Error codes or diagnostic indicators are not explicitly mentioned, but technicians are advised to check voltage measurements at specified points, ensuring they align with the expected values, such as 6VAC and 95V. Calibration involves adjusting the modulating frequencies, with the radio frequency set between 113 to 172 KC for horizontal linearity and approximately 480 cps for vertical linearity. The output voltage should be maintained at 100,000 microvolts. For board-level guidance, technicians should inspect the VHF oscillator coil and verify the integrity of components such as capacitors and resistors, ensuring values like 270 MMF and 2000 MMF are correct. Proper functioning of the neon lamp and oscillator coil is crucial for optimal performance. The manual emphasizes the importance of accurate voltage measurements and component verification to maintain the generator’s efficiency.
Quick Issues Covered
- Diagnose power-up failures with transformer and rectifier checks.
- Adjust vertical linearity using 480 cps modulating frequency.
- Reference schematics for troubleshooting VHF oscillator coil issues.
Overview
HEATHKIT BAR GENERATOR MODEL BG-1 is a device with a carrier frequency range of 60 to 80 megacycles. It features modulating frequencies for radio frequency (horizontal linearity) from 113 to 172 KC and low frequency (vertical linearity) at approximately 480 cps. The output voltage is 100,000 microvolts. It operates with a transformer-operated half-wave selenium rectifier power supply, requiring 105-126 volts, 50-60 cycles AC. The dimensions are 8 1/8″ wide, 4 3/8″ high, and 4 7/8″ deep, with a shipping weight of 6 lbs.
Specifications
- Carrier Frequency: 60 to 80 megacycles
- Modulating Frequencies Radio Frequency (Horizontal Linearity): 113 to 172 KC
- Low Frequency (Vertical Linearity): 480 cps. (Approx.)
- Output Voltage: 100,000 microvolts
- Tube: 12AT7
- Power Supply: Transformer operated half-wave selenium rectifier
- Power Requirements: 105-126 volts, 50-60 cycles AC
- Dimensions: 8 1/8" wide, 4 3/8" high, 4 7/8" deep
- Shipping Weight: 6 lbs.