Hammarlund HQ-170A-2 Meter Converter 6 Meter Pre Amplifier Instruction Book Addendum (PDF)

The manual for the Hammarlund HQ-110A/VHF and HQ-170A/VHF receivers provides detailed instructions for setting up, operating, and troubleshooting the equipment, including how to receive 6-meter and 2-meter signals using specific bandswitch positions and antenna connections. It also explains the improved sensitivity on the 6-meter band due to a low noise pre-amplifier and includes a field alignment procedure requiring specific tools and a signal generator.

  • Brand: Hammarlund
  • Model: HQ-170A-2
  • Type: manual
  • File size: 1.4 MB

Manual Overview

The Hammarlund HQ-110A/VHF and HQ-170A/VHF receivers are designed for amateur radio frequencies from 160 meters to 2 meters, with enhanced sensitivity on the 6-meter band due to a low-noise 6CW4Y pre-amplifier. Troubleshooting involves ensuring proper antenna connections and using separate antennas for 6 and 2-meter operations. Calibration requires a signal generator and alignment tools, with specific procedures for tuning coils and capacitors to peak performance. For example, L205 and L206 should be adjusted for peak readings on a meter when tuned to 50 Mc, while L211 is tuned for minimum readings. Error diagnostics are not explicitly detailed, but alignment issues can be addressed by following the alignment procedure, which includes unsoldering and resoldering specific leads and adjusting various coils for maximum or minimum readings. The manual emphasizes the importance of using a good antenna and following the recommended alignment procedure to maintain optimal receiver performance.

Quick Issues Covered

  • Diagnose 6CW4 pre-amplifier power-up failures on HQ-110A/VHF.
  • Calibrate L205 and L206 for optimal 6-meter signal reception.
  • Trace circuit using HQ-110A/VHF schematic for alignment issues.

Overview

The Hammarlund HQ-110A/VHF and HQ-170A/VHF are receivers capable of tuning all amateur frequencies from 160 meters through 2 meters, providing reception for CW, AM, and SSB signals. The manual covers operation instructions, including how to receive 6-meter signals and the importance of using separate antennas for 6 and 2-meter operations. It also details the theory of operation, including the use of a low noise pre-amplifier stage and a frequency converter for improved sensitivity. The manual includes a field alignment procedure and emphasizes the importance of using a good antenna for optimal performance.

Operation

To receive 6 meter signals (50 to 54 Mcs), place the bandswitch in the 50 to 54 Mc position and push in the volume control knob. Connect a suitable antenna to the proper antenna terminal. For 2 meter signals (144 to 148 Mc), pull out the volume control knob to turn on frequency converter stages, which change 144 to 148 Mc signals to 50 to 54 Mc signals. When not receiving 2 meter signals, it is recommended to push in the volume control knob to reduce power consumption. Separate antennas are recommended for 6 and 2 meter operation, and a switching unit should be used if a combination 6/2 meter antenna is desired. The sideband switch is reversed on six and two meters, resulting in the upper sideband being received in the lower sideband position and vice versa.

Download PDF (1.4 MB)

Leave a Comment