The manual for the Hammarlund schematics provides detailed instructions for setting up, operating, and troubleshooting the HQ-170 Communications Receiver, including information on the noise limiter, amplifier, and tuning adjustments. It also specifies the components like resistors and capacitors, along with their values and placements, to aid in the effective maintenance and repair of the device.
Manual Overview
The manual for Hammarlund SCHEMATICS focuses on the HQ-170 Communications Receiver, providing detailed guidance for technicians on troubleshooting, diagnostics, and calibration. The troubleshooting flow involves checking signal pathways and component connections, particularly focusing on the noise limiter, IF amplifiers, and AVC circuits. Error codes and diagnostics are not explicitly detailed in the schematic, but technicians are advised to verify component values and connections as per the schematic to identify faults. Calibration and adjustments are crucial for optimal performance, with specific attention to the 455 KC and 60 KC IF stages. Adjustments can be made using the vernier tuning and coarse/fine adjustments on the front panel. Board-level guidance includes verifying resistor and capacitor values, noting that all resistors are 1/2W with a 10% tolerance unless specified otherwise, and capacitors are measured in micro-microfarads. Technicians should ensure correct terminal connections, as indicated by terminal locating lugs, to maintain proper functionality of the receiver.
Quick Issues Covered
- Diagnose power-up failures with voltage checks at key points.
- Adjust fine tuning using C26 and C30 on front panel.
- Trace circuits using detailed schematic for component identification.
Specifications
- 455 KC 3RD MIXER
- 6OKC I.F AMP
- 6BV8
- 6BA6
- R24 120 5%
- R25
- R26 200
- C37 820
- C46 VO-6ALS
- C42
- R43
- C39
- R36
- R76
- C31 500K
- C25 10% 100K
- C32
- C27
- R77
- R79
- C26
- C30
- R50
- C18
- R66
- C23
- R97
- C78
- R69
- R22
- R88 500