The manual provides detailed installation instructions for setting up the VHF Converter (HQ-170), including steps such as connecting various wires and coax cables, removing specific components, and installing a new audio pot with a switch. It also includes a parts list with descriptions and part numbers for components needed during the setup process.
Manual Overview
The Hammarlund manual for the VHF Converter (HQ-170) primarily focuses on installation and modification procedures rather than direct troubleshooting or diagnostics. However, understanding these modifications can aid in troubleshooting. The manual details specific wiring changes, such as connecting coax cables with color-coded tape to designated antenna jacks and removing or relocating wires from antenna terminal posts. Adjustments include installing a new audio pot with a switch and changing resistor values from 3000 ohms to 2500 ohms. These modifications are crucial for ensuring proper operation and can help diagnose issues related to incorrect wiring or component failures. While the manual does not provide explicit error codes or diagnostics, following the installation instructions carefully can prevent common setup errors. For board-level guidance, the manual specifies connections to various pins and terminals, which are essential for maintaining correct circuit functionality. Calibration and adjustments are implied through the component changes and wiring instructions, ensuring the converter operates within its intended parameters.
Quick Issues Covered
- Diagnose power-up failures related to incorrect antenna connections.
- Calibrate crystal circuit by adjusting removed 8 pf capacitor.
- Use schematics for tracing coax connections to antenna jacks.
Overview
The document provides installation instructions for a VHF Converter (HQ-170). It includes detailed steps for connecting various wires and components, such as antenna jacks, coax cables, and resistors, to the converter. The instructions also mention parts needed for the installation, including an audio pot switch, a resistor, and self-tapping screws.
Installation / Setup
The installation instructions for the VHF Converter (HQ-170) include several key steps. These involve loosening the filter choke without moving it to install the assembly, adding a 2-meter antenna jack to the back of the chassis, and connecting coax cables with red and blue tape to specific antenna jacks. Various wires are removed and reconnected to different terminal posts and switch wafers, including the removal of an 8 pf capacitor from the crystal calibrator circuit. Additional steps include connecting coax cables to the 6-meter antenna coil, connecting wires to specific pins of the 12AU7 (V13), installing a new audio pot with a switch, and making changes to certain resistors.