The Drake DMM 806 Video Demodulator System manual provides instructions for setting up the device, including connecting it to a television antenna or CATV feed and selecting the desired channel using front panel controls. It also covers troubleshooting steps, such as ensuring proper connections and settings, and emphasizes the importance of correct maintenance and repair for optimal performance.
Manual Overview
The Drake DMM 806 Video Demodulator System manual provides detailed guidance on troubleshooting, error diagnostics, and system calibration. For troubleshooting, the manual emphasizes the importance of verifying connections and ensuring correct settings on the front panel switches for channel selection. Error codes or diagnostics are not explicitly detailed, but the manual suggests checking the integrity of the electrical connections and the associated equipment if issues arise. Calibration and adjustments involve using the front panel controls to set the desired off-air or CATV channel and adjusting the audio output level. The manual also provides board-level guidance, indicating that the RF input and video output connections are located on the rear panel, and adjustments can be made via the front panel switches. The system is designed to work with a compatible Drake Mini-rack power supply, and proper ventilation is recommended to ensure optimal performance and longevity of the components.
Quick Issues Covered
- Diagnose power-up failures via rear panel DC input connector.
- Adjust audio output level with front panel control.
- Set channel type and number using front panel switches.
Specifications
- Input Frequency: 54 – 806 MHz
- Output Level: 300 mV rms nominal
- Off air channels: 2 – 69
- CATV channels: 2-125
- Input Level: -10 to +35 dBmvV
- Noise Figure: VHF: 8 dB, UHF: 10 dB
- Image Rejection: VHF: 65 dB, UHF: 50 dB
- Input Impedance: 75 Ohms
- Output Level: 1.0 Vp-p, NTSC standard negative sync
- Output Impedance: 75 Ohms
- Differential Gain: Less than 5%
- Differential Phase: Less than 5 degrees
- L/C Delay: +50 nSec maximum
- DC Power Input: +12 VDC @ 120 mA, +5 VDC @ 100 mA
- Operating Temperature: 0° C to +50° C
- Dimensions: 1” Wx 3.5” Hx 7.5” D
- Weight: 12 oz
Controls & Indicators
F1 – POWER Indicator: Lights when the unit is connected to the required source of DC power via the rear panel DC INPUT connector.
F2 – Channel Number Switch: Sets the received channel number for off-air TV channels 02 through 69 or for CATV channels 02 through 125. See also Item F3 which sets the type of channel (Off-Air or CATV) and sets the leading “1” for CATV channels 100 through 125.
F3 – Mode Switch: Sets the type of channel, Off-Air or CATV.
F4 – AUDIO Control: Adjusts the audio output level over a range of approximately +10 dB from the nominal output level of 300 mV rms.