The Drake DD860 Digital Demodulator manual provides detailed instructions for setting up, operating, and troubleshooting the device, which is designed to demodulate VSB or QAM signals from terrestrial or CATV feeds. It includes information on power supply connections, channel selection, signal-to-noise ratio indicators, and error indicators, ensuring optimal performance and reliable operation within specified frequency ranges.
Manual Overview
The Drake DD860 Digital Demodulator is a modular component designed for optimal VSB or QAM demodulation, handling signals from terrestrial broadcasts or CATV feeds within the 54 to 858 MHz range. It outputs an MPEG-2 digital transport stream and supports various modulation formats including 8 VSB, 16 VSB, 64 QAM, and 256 QAM. The unit features front panel indicators for signal-to-noise ratio and status, with thresholds set at 15 dB for 8 VSB, 29 dB for 16 VSB, 23 dB for 64 QAM, and 28 dB for 256 QAM. Troubleshooting involves checking these indicators and ensuring proper antenna alignment if errors occur. The demodulator includes an NTSC co-channel rejection filter and a wide-range equalizer to mitigate multipath effects. It supports both ITU A (DVB) and ITU B (DigiCipher II) FEC standards. The DD860 is rack-mountable in a DRMM12 enclosure and powered by a PS8 power supply. Channel selection is managed via front panel switches, with internal jumpers available for IRC and HRC formats. The unit provides two 75 Ohm ASI outputs, with an optional SPI output available.
Quick Issues Covered
- Diagnose FEC errors with front panel error indicator.
- Calibrate signal-to-noise ratio using LED meter.
- Resolve power-up failures with PS8 power supply.
Overview
The R.L. Drake model DD860 Digital Demodulator is a professional quality modular digital headend component designed for VSB or QAM demodulation. It receives signals in the 54 to 858 MHz range and outputs an MPEG-2 digital transport stream. The DD860 supports 8 VSB, 16 VSB, 64 QAM, or 256 QAM signals and features a low phase noise tuner, NTSC co-channel rejection filter, and a wide range equalizer. It provides two 75 Ohm serial ASI outputs and an optional parallel SPI output. The device is designed to mount in the DRMM12 rack mounting cage and is powered by the PS8 power supply module.
Specifications
- RF INPUT
- LVDS OUTPUT
- ASI TRANSPORT STREAM OUTPUT
- Signal-to-Noise Ratio Meter
- CHANNEL Selector Switch
- ERROR Indicator
- BNC Connectors (ASI output model)
- 25 Pin SPI LVDS OUTPUT Connector
Controls & Indicators
The front panel of the DD860 Digital Demodulator includes signal-to-noise ratio and status indicators.
Installation / Setup
The DD860 Digital Demodulator is designed to be installed into the DRMM12 rack mounting enclosure. It requires a minimum vertical spacing of 1 3/4″ between DRMM12 frames for adequate ventilation, as air movement is essential to prevent excessive heat, which can reduce component lifespan. Power should be supplied by the PS8 power supply module, which also fits into the DRMM12. All connections are made through the rear panel, and correct cable and wiring connections can be referenced in Figure 4.