The manual for the B&K Precision Model T472C oscilloscope covers setup procedures such as initial starting, waveform observation, and calibration adjustments. It also provides detailed instructions for operation, including the use of controls and indicators, as well as troubleshooting techniques for various applications like television servicing and amplifier testing.
Manual Overview
The B&K Precision Model T472C Oscilloscope manual provides detailed guidance on operating and troubleshooting the 15 MHz triggered sweep dual-trace oscilloscope. For troubleshooting, the manual emphasizes the importance of understanding the oscilloscope’s controls and indicators, such as the cathode ray tube (CRT) for waveform viewing, and the various switches and controls for adjusting sweep time, triggering, and vertical and horizontal positioning. Error diagnostics involve checking the calibration of the vertical amplifier attenuators using the calibrated 1 kHz, 1 volt peak-to-peak square wave input signal. Calibration and adjustments are crucial, with specific instructions for housing removal, DC balance adjustments for channels A and B, and gain adjustments. The manual also provides board-level guidance, describing the circuit components like vertical preamplifiers, mode logic, and trigger circuits. Technicians are advised to follow the initial starting procedures and use the oscilloscope’s features for various applications, including waveform observation and voltage measurement, ensuring accurate diagnostics and maintenance.
Quick Issues Covered
- Diagnose power-up failures with initial starting procedures.
- Calibrate voltage measurement using 1 kHz, 1V P-P square wave.
- Trace circuits using detailed schematic diagrams for troubleshooting.
Overview
The product is a B & K Precision Model T472C, a 15 MHz triggered sweep dual-trace oscilloscope. The manual covers various aspects of the oscilloscope, including its features, specifications, operator’s controls, indicators, facilities, and detailed operating instructions. It also includes sections on dual-trace and single-trace applications, television alignment, FM receiver alignment, phase and frequency measurement, square wave testing of amplifiers, circuit description, and calibration adjustments. Warranty service instructions are also provided.
Specifications
- 15 MHz, TRIGGERED SWEEP
- Dual Trace Oscilloscope
Controls & Indicators
The front-panel controls and indicators of the B & K Precision Model T472C 15 MHz Triggered Sweep Dual-Trace Oscilloscope include:
1. Cathode Ray Tube (CRT) – The screen for viewing waveforms.
2. Scale – 8 x 10 cm graticule for calibration marks.
3. POWER ILLUM control – Turns the oscilloscope on/off and adjusts scale illumination.
4. Pilot lamp – Indicates when the oscilloscope is on.
5. SWEEP TIME/CM switch – Selects horizontal sweep time.
6. Sweep speed VARIABLE control – Fine sweep time adjustment.
7. CAL 1V P-P jack – Provides a calibrated square wave for calibration.
8. POSITION control – Adjusts horizontal position of traces.
9. TRIGGERING LEVEL control – Adjusts sync level for sweep start.
10. EXT TRIG jack – Input for external trigger signal.
11. SYNC switch – Selects sync positions for waveforms.
12. SOURCE switch – Selects triggering source for the sweep.
13. Channel B POSITION control – Adjusts vertical position for Channel B trace.
14. Channel B DC BAL adjustment – Vertical DC balance for Channel B trace.
15. Channel B INPUT Jack – Vertical input for Channel B.
16. Channel B DC-GND-AC switch – Selects input type for Channel B.
17. Channel B VOLTS/CM switch – Vertical attenuator for Channel B.
18. Channel B VARIABLE control – Fine control of vertical sensitivity for Channel B.
19. MODE switch – Selects operating modes of the oscilloscope.
20. Channel A VOLTS/CM switch – Vertical attenuator for Channel A.
21. Channel A VARIABLE control – Fine control of vertical sensitivity for Channel A.
26. ASTIG adjustment – Adjusts spot roundness.
27. FOCUS control – Adjusts focus of the display.
28. INTENSITY control – Adjusts brightness of the display.