Rohde & Schwarz SMT Signal Generator Service Manual Vol3 German English (PDF)

The Rohde & Schwarz SMT Signal Generator Service Manual Volume 3 includes detailed instructions for testing and repairing various modules such as the 3 GHz and 6 GHz calibration lines, and options like the reference oscillator and pulse modulator. It also provides safety instructions to ensure safe operation, emphasizing the importance of maintaining the protective ground connection and using original parts for safety-related replacements.

  • Brand: Rohde & Schwarz
  • Type: service manual
  • File size: 8.5 MB

Manual Overview

The Rohde & Schwarz SMT Signal Generator Service Manual Volume 3 provides detailed guidance on troubleshooting, error diagnostics, calibration, and board-level repairs. It emphasizes the importance of following safety instructions to maintain the device’s operational integrity. The manual outlines procedures for testing and repairing various modules, including the 3 GHz and 6 GHz calibration units, and options like the reference oscillator OCXO and pulse modulator. Technicians are advised to isolate the unit from the AC supply before opening it and to use only original parts for safety-relevant components. The manual includes a section on error codes and diagnostics to assist in identifying and resolving issues efficiently. Calibration and adjustment procedures are detailed to ensure accurate signal generation. Only authorized specialists should perform maintenance and repairs, adhering to safety regulations and using the manual’s guidance for specific module repairs.

Quick Issues Covered

  • Diagnose and repair 3 GHz and 6 GHz calibration modules.
  • Troubleshoot OCXO reference oscillator and LF generator options.
  • Address power-up failures and protective ground connection issues.

Overview

The source provides information about a service manual for the Rohde & Schwarz SMT signal generator. The manual is divided into three volumes and includes safety instructions, repair instructions, and testing and repair of various modules.

Safety & Warnings

This unit has been designed and tested according to safety standards and left the manufacturer’s premises in a compliant state. To maintain this state and ensure safe operation, the following instructions and precautions should be observed:

1) When permanently cabling the unit, connect the protective ground conductor before making any other connections.
2) Built-in units should only be operated when properly fitted into the system.
3) For permanently cabled units without built-in fuses, automatic switches, or similar protective facilities, the AC supply line should be fitted with fuses rated to the units.
4) Before switching on the unit, ensure that the operating voltage set at the unit matches the line voltage. If a different operating voltage is to be set, use a fuse with the appropriate rating.
5) Units of protection class I with a disconnectible AC supply cable and plug may only be operated from a power socket with a protective ground contact. The protective ground connection should not be made ineffective by an extension cable. Any breaking of the protective ground conductor within or outside of the unit or loosening of the protective ground connection may cause the unit to become electrically hazardous. The protective ground conductor shall not be interrupted intentionally.
6) Before opening the unit, isolate it from the AC supply. Adjustment and replacement of parts, as well as maintenance and repair, should be carried out only by specialists approved by R&S. Observe safety regulations and rules for the prevention of accidents. Use only original parts for replacing parts relevant to safety (e.g., power on/off switches, power transformers, or fuses).
7) Also observe the additional safety instructions specified in this manual.

Explanation of Symbols Used:
– Read operating manual, observe the safety symbols used.
– Caution, shock hazard.
– Protective ground connection.
– Unit ground.
– Equipotentiality.
– Ground.

Download PDF (8.5 MB)

Leave a Comment