The manual for the R&S RT-ZH10 400 MHz Passive High-Voltage Probe provides detailed instructions on setup, operation, and safety precautions, including proper grounding and connection procedures to ensure accurate measurements and prevent damage. It also includes troubleshooting tips, specifications for electrical performance, and compliance with safety standards such as the Low Voltage Directive and IEC safety requirements.
Manual Overview
The operation manual for the R&S RT-ZH10 400 MHz Passive High-Voltage Probe provides detailed guidance on its use, focusing on troubleshooting, error diagnostics, and calibration. The probe is designed for measurements in various IEC measurement categories, with specific voltage and frequency ratings that must be adhered to for safe operation. Troubleshooting involves ensuring proper grounding and connection sequences to avoid impairing the probe’s protection capabilities. Error diagnostics are facilitated by observing the probe’s response to different input conditions, with specific attention to voltage and frequency derating curves. Calibration and adjustments require checking the attenuation ratio and compensation range to maintain accuracy. The manual emphasizes the importance of understanding the probe’s input impedance and maximum pulse ratings to prevent overloading. Board-level guidance includes ensuring the probe is used in suitable environmental conditions, avoiding wet or explosive atmospheres, and adhering to pollution degree specifications. The manual underscores the necessity for qualified personnel to handle the probe, ensuring compliance with safety standards and proper disposal according to WEEE/RoHS directives.
Quick Issues Covered
- Diagnose power-up failures using voltage derating curves.
- Identify error codes related to input impedance variations.
- Trace circuit schematics for probe calibration adjustments.
Overview
The R&S® RT-ZH10 is a 400 MHz passive high-voltage probe designed for test and measurement applications. The manual includes safety information, electrical specifications, and guidelines for proper usage to prevent personal injury and equipment damage. It covers the probe’s attenuation ratio, voltage coefficient, system bandwidth, input resistance and capacitance, maximum rated input voltage, compensation range, and input coupling. Additionally, it provides information on measurement categories, pollution degrees, and safety symbols. The manual emphasizes the importance of using grounded instruments and adhering to specified ratings and derating curves.
Specifications
- Attenuation Ratio 100:1 +2% at DC (warranted)
- Voltage Coefficient 0.0005 %/V
- System Bandwidth 400 MHz (-3 dB)
- Probe Risetime 900 ps (10 % – 90 %)
- Input Resistance (System) 50 MΩ +1% (warranted)
- Input Capacitance (System) 7.5 pF
- Maximum Rated Input Voltage
- Measurement category I: 1000 V root mean square, 4000 V transient overvoltage
- Measurement category II: 1000 V root mean square CAT II
- Compensation Range 5 pF – 20 pF
- Input Coupling of the Measuring Instrument 1 MΩ AC/DC
- Pollution Degree 2
Safety & Warnings
To avoid personal injury and to prevent fire or damage to the product or connected products, the following safety precautions must be reviewed and complied with:
– Only qualified personnel should use the probe assembly.
– Use only grounded instruments.
– Do not connect the probe ground lead to a potential other than earth ground. Ensure the probe and the measurement instrument are properly grounded.
– Connect the probe output to the measurement instrument and the ground lead to earth ground before connecting the probe to the circuit under test. Disconnect the probe input and the probe ground lead from the circuit under test before disconnecting the probe from the measurement instrument.
– Observe probe and probe accessory ratings. Do not apply any electrical potential to the probe input that exceeds the maximum ratings of the probe or the accessories connected to it. The lower rating/measurement category applies to both the probe and accessories.
– Comply with the voltage versus frequency derating curve.
– Keep away from live circuits and avoid open circuitry. Do not touch connections or components when power is present.
– Do not operate with suspected failures and refer to qualified service personnel.
– Indoor use only. Do not operate in wet/damp environments and keep product surfaces dry and clean.
– Do not operate the product in an explosive atmosphere.